Arduino Blink Led Code

-

 const int LED_PIN = 13;


void setup() {
pinMode(LED_PIN, OUTPUT);
}

void loop() {
digitalWrite(LED_PIN, HIGH);
delay(1000);
digitalWrite(LED_PIN, LOW);
delay(1000);
}

Comments

Post a Comment

Popular posts from this blog

ESP32 Wi-Fi Extender Code

-
 #include <WiFi.h> // Credentials of existing WiFi const char* ssid = "Your_WiFi_SSID"; const char* password = "Your_WiFi_Password"; // Credentials for new AP const char* ap_ssid = "ESP32_Extender"; const char* ap_password = "12345678"; void setup() {   Serial.begin(115200);   // Connect to existing WiFi   WiFi.begin(ssid, password);   Serial.print("Connecting to WiFi");   while (WiFi.status() != WL_CONNECTED) {     delay(1000);     Serial.print(".");   }   Serial.println("Connected!");   // Start Access Point   WiFi.softAP(ap_ssid, ap_password);   Serial.println("Access Point Started");   Serial.print("AP IP Address: ");   Serial.println(WiFi.softAPIP()); } void loop() {   // Nothing needed here }
Read more