Arduino Inverter Code

-

 void setup() {

pinMode(3, OUTPUT); // Set digital pin 3 as output
}

void loop() {
 digitalWrite(3, HIGH); // Turn MOSFET ON
 delayMicroseconds(8333); // Wait for ~8.333 ms (half-period)
 digitalWrite(3, LOW); // Turn MOSFET OFF
 delayMicroseconds(8333); // Wait for ~8.333 ms
}


Comments

Post a Comment

Popular posts from this blog

ESP32 Wi-Fi Extender Code

-
 #include <WiFi.h> // Credentials of existing WiFi const char* ssid = "Your_WiFi_SSID"; const char* password = "Your_WiFi_Password"; // Credentials for new AP const char* ap_ssid = "ESP32_Extender"; const char* ap_password = "12345678"; void setup() {   Serial.begin(115200);   // Connect to existing WiFi   WiFi.begin(ssid, password);   Serial.print("Connecting to WiFi");   while (WiFi.status() != WL_CONNECTED) {     delay(1000);     Serial.print(".");   }   Serial.println("Connected!");   // Start Access Point   WiFi.softAP(ap_ssid, ap_password);   Serial.println("Access Point Started");   Serial.print("AP IP Address: ");   Serial.println(WiFi.softAPIP()); } void loop() {   // Nothing needed here }
Read more